benji09

Thanks it's getting there

Bulkhead finally done and fitted

This side wasn't as bad so didn't need a full panel

Just a bit of weld to clean off then the other side to start

Start off with happy new year Rebuilding my 90 because it fell on its side Got them the wrong way round

Lol no but the centre box made a good appearance lol

It's was in very slow motion

I was on a little slope trying to pop a spring back in and when moving forwards after the spring went in it slipped on a flat rock and slid the front end over and the rest is in the pics and to top it off the spring came back out

There is more in my gallery lol

Lol I did try but the pics on my phone were a little too big

Thanks for the help I re did all four just for peace of mind plus had a really good look at them today and found a couple of the little metal cap things where missing of the ujs both front and rear I wormed the grease up before I greased them in hot/warm water think my next job is going to be the rear a frame ball joint but thinking of getting one already pressed in been told they can be a pain to press out but thanks aging guys for the info and help much appreciated