jonost24

Will you be using the MS relay board, or doing your own thing?

I read somewhere that there should be a 0.004" gap approx between the butterfly and the housing. Is that the case?

Good shout Ron, but then I'd have to buy a welder, learn to weld then do the job .............might be a bit costly for some flanged nuts

Cheers Daily that's useful. Would you know the best place to get these?

Evening All, Just put the roof back on my 90 after a long time. I have all the nuts and bolts to fit the roof, but appear to have mislaid the six that fix the windscreen frame at the top. Can some one tell me if they are the nuts attached to plates to stop them spinning whilst being tightened? I have found a couple of these, and it seems to be logical because of access to hold a standard nut. If someone can confirm this, or otherwise, where can I purchase some from. Regards Jon

I've got a couple of 400w security lights wired into the garage. Great light, but can create shadows without additional lighting. Cheap to buy

It's a bit of Basil Fawlty.....don't mention the war

Nice Truck

That'll be the Viagra then

The mods might want to move this to videos?

This is great..... http://youtu.be/bC-U3O5lzAQ .....including MS

I'm sure it's ok, but when you jack the Landy up have you got the height?

Thanks for the pointers guys

I don't know for sure, but in the moist mornings you may get condensation on the plastic. I roofed my garage with the plastic corrugated sheeting, and had lines of drips where the battens were fixed, all along the floor and car. I had to remove the sheeting and put underfelt underneath. Top job now, that was about 12 years ago. The underfelt and plastic are still going strong. My garage is about 12' x 30', although it was built before I had my 90, so I had to remove the roof and door off the 90 to get it in to work on it..lol