Jump to content

gavinl

Getting Comfortable
  • Posts

    7
  • Joined

  • Last visited

Reputation

0 Neutral
  1. You can download the Land-Rover manuals, wiring diagrams are in number 5, from: http://www.landroverweb.com/landrover/pdf-land-rover-manuals/ On checking I see that mine is purple/white at the switch. According to the manual it changes to purple from the interior light.
  2. On the door pillar the interior light switch switch, on the driver's side, has a black wire and a purple/black wire. There is no contiuity to earth for the black wire and the purple/black wire vanishes. 1. Please can somebody tell me where these two wires come out of the door pillar? 2. Where does the light switch on the passenger side wire go to?
  3. My 109 developed a new problem recently, on LPG the engine wouldn't pull below 2000 RPM. The air filter for the snorkel is in the mushroom top and the snorkel pipe is connected to the carburettor elbow by a long rubber pipe. I also wanted to connect up a Lambda sensor with a stepper motor to the LPG control system but the instructions were incomprehensible. So down to my local LPG expert, Alan Ponting (0783 339 8695) at Caxton Gibbet, Cambs. The Lambda system was installed in no time. But diagnosis of the lack of power was more problematic. After a variety of experiments the cause was found to be a harmonic resonance in the snorkel pipe that caused the vapouriser diaphram to oscillate chaotically. The cure was to fit an "airbox" between the snorkel pipe and rubber pipe to disrupt the resonance. If you are looking for someone to do LPG conversions, any vehicle, repairs or just certification don't hesitate to check out Alan for good value workmanship.
  4. How did you make your own manifold?
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy