PieEater3142

Connector for PDWA Sensor

8 posts in this topic

I have a 200tdi 110 with a PDWA sensor on it. I have made a new loom for the car and I never saw anything but moulded bullets on the old loom but I need something to connect to the PDWA sensor (AAU1700).

Basically I need the connector for this: http://www.lrseries.com/shop/product/listing/2249/3005/1/AAU1700-BRAKE-PRESSURE-SWITCH.html

Does anyone know what this connector is? I called Craddocks and they said you can't buy it separately and it's part of the loom. Anyone know if this plug has a part number or where I can get one?

Cheers,

James

Share this post


Link to post
Share on other sites

had a remove of mine from the PDWA valve, it's wet outside & dark, photo's below, IIRC it wasn't part of my new bulkhead loom when I fitted it a few years ago, looks to be a seperate sub harness.

I'll have a trawl through my 110 parts book & see if I can find a number

post-20-0-19210400-1328556539_thumb.jpg

post-20-0-87435800-1328556570_thumb.jpg

Share this post


Link to post
Share on other sites

So I emailed autosparks, the response was not great:

Hi James

Sorry, this plug is now obsolete !

Regards

Debbie

Think I need to put a brake fluid level sensor in instead. :(

Share this post


Link to post
Share on other sites

LR ditched the PDWA when the 300tdi's came out, replaced with the low fluid switch in master cylinder cap, easy to add, fited one to my 110 recently, got the new float cap from my local LR parts place, it;s this one http://www.lrseries.com/shop/product/listing/15827/4298/1/SJL100200-BRAKE-MASTER-CYLINDER-RESERVOIR-CAP.html if you decide to fit it, needs 2 wires one to earth & one to the black/white wires where the PDWA wiring connects [i run both inline]

Share this post


Link to post
Share on other sites

I have two wires for the pdwa. One from the relay and one to the warning bulb. which of these wants to go where? Sorry but lost here. Thanks for the link.

Share this post


Link to post
Share on other sites

I have a 200tdi 110 with a PDWA sensor on it. I have made a new loom for the car and I never saw anything but moulded bullets on the old loom but I need something to connect to the PDWA sensor (AAU1700).

Basically I need the connector for this: http://www.lrseries....URE-SWITCH.html

Does anyone know what this connector is? I called Craddocks and they said you can't buy it separately and it's part of the loom. Anyone know if this plug has a part number or where I can get one?

Cheers,

James

Those PDWA Switches were used on lots of British made cars, here's a connector I found at a Triumph specialist, I think it's the same type -

http://www.ldparts.c...a478a0577be22eb

829.jpg

.

Share this post


Link to post
Share on other sites

looks the same end plug as mine, but without the black weather protecting cover.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now