Jump to content

moto.hi

New Faces
  • Posts

    1
  • Joined

  • Last visited

Reputation

0 Neutral

Profile Information

  • Location
    Hawaii

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I've had coolant leak issues for a while and finally did a pressure test and realized the head gaskets were shot. Since this ill be the second time around I measured the heads and also realized I was going to need to get new heads as they had already been machined to the limits. I picked up a new set via a facebook group from a guy who had stated they were tested and ready to go. Once they got here (I live in Hawaii) I measured the and low and behold they too are out of spec according to the RAVE overhaul manual. Here's what I have. A few people have said I should be ok even though they are about .25 mm over what the RAVE says. I'm wondering what folks on here think. And if maybe using slightly thicker gaskets - if thats even an option - would be a good idea. Drivers Side A - 22.19 mm B - 61.84 mm Passenger side A - 22.25 mm B - 61.88 mm 02 D2 SD - 138k, L8 4" TF Lift, TF shock turrets, TF panhard & steering rods, Tom Woods front double cardon drive shaft, TF 1" spacers, TF rock sliders, Britpart HD rear bumper
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy