Hi AllLooking for some help with wiring up some work light / reverse lights onto my 2002(52) Defender TD5 110 CSW.I've got 2 x good quality LED lights which I am planning to mount high up either side of the rear door to shine down & back and a MUD OEM style dash mounted control switch which I want to use to control it.Ideally I'd like to have it so that when the switch is depressed then when I select reverse they will come on so that normally the switch is left on and triggered by going into reverse. This will mean I can use as work lights by knocking the transfer box into neutral and also means I won't forget to switch them off when I come out of reverse etc.Mud have supplied a wiring loom diagram for the switch (attached) but I would have thought pin 86 should be an earth and also not sure where my feed from reverse lights to trigger switch would fit into this? Looking for some advice on how best to tackle this and if anyone has done something similar that has any handy do's or dont's on doing it!Any and all help/advice would be welcome!Thanks
