The gears of my LT77 gearbox aren't fully clicking in. The car still drives normally however, I realised that the gearstick isn't going in as much as it used to before and its a lot more difficult to find the gears whilst driving. Any suggestions on how to fix it or what might have caused this? Much appreciated!
Hi all
I am rebuilding my Land Rover defender 90 and realised that I forgot to fit the heater bezel MUC4801 and the seal MTC6871 onto the bulkhead. Could someone tell me what this bezel / seal does and if it is important enough to dismantle the dashboard again and fit it.
Thanks
Kurt
Hey guys
Over the past 2 years Ive been dismantling and rebuilding my land rover defender 200tdi. Ive started re assembling the body and come to put the wheel arches back on however, I seem to have mixed up the brackets (or have a missing part) as I dont have a hole aligned for the RHS inner wheel arch.
I found an old photo I had taken of both brackets… can someone confirm if I have anything missing please?
my defender also has a pressure reducing valve which I have added a photo of too.
Does anyone know if these HD steering rods are the right ones to do a discovery drop on conversion on my defender 90. I asked paddock and they were unsure.
https://www.paddockspares.com/pm1012-heavy-duty-steering-rods-for-range-rover-classic-and-discovery-1-with-4-lemforder-oe-ball-joints.html
I previously bought HD steering rods only to find out they were the wrong ones (the drag link was too short) . Dont want to make the same mistake twice.
I am looking for ways to add an AC to my Defender 90 TDI 200 (without using the traditional under-dash vents that take up a lot of leg room). I saw a guy who had created custom vents on a MUD console so im looking for any suggestions or advice as to how I can install an AC similar to the one below.
PS: I dont have any experience in AC Units so I'd appreciate any suggestions
Thanks for the advice! Much appreciated!
However should I put the engine in before the bulkhead or after? Thought it might be easier to get started with the TDI200 / LT77
Thanks
Hey guys, I recently dismantled my defender 90 tdi200, had the chassis galvanised and have now rebuilt it back to a rolling chassis with a new suspension.
I was wondering if anyone has any suggestions on how I should proceed in rebuilding it. (It's my first rebuild project). Any advice on what I should put back in first and in what order?