SCHREIBER

Hi all, With the MOT looming(10:30 tomorrow!) I'm coming to the end of my 90 re-build! But I can't get a good pedal on the brakes. I've fitted all new lines, braided hoses, new pads and discs and a new master cylinder. I can get an average pedal when pumped repeatedly, but no where near the rock solid it should get. I've got no leaks in the system either. I keep getting air out of the bleed nipples, but the pedal never gets better, straight to the floor! Does anyone have any ideas or suggestions please?!?!?! Thanks Chris

Thanks for the numbers fella's, none of them work, and still no reply to emails. Its taking the tiddle somewhat! Chris

I've sent and email, but no reply, Its not the fax line, i've ringed that too, hoping they had the numbers mixed up on the website! Its a pretty ridiculous situation. chris

Good morning folks, I've bought some items from qt services this week, I need to contact them, but there number on their website dosn't accept incoming calls! has anyone got another number i can try them on? ta Chris

So the input shaft length is the same in defender and disco r380 boxes?

Thanks for the replys everyone! So I'm looking for a r380, which I belive is the same in the disco as the defender? With a v8 belhousing and input shaft? Is this correct? Or failing that, a lt85? Thanks Chris

Hi folks, I'm building a V8 90 over the winter, using a serp 3.9 or larger rover unit. I want to have a manual box behind the V8, not auto. What options do I have regarding gearboxes? Can the Lt77 90 box be converted to mate to the v8? Or is there other boxes I can use? Thanks Chris

I sharp stanley gives a neater cut, and as long as you can follow the line you've drwan, it will be pretty straight.

Draw the line you want to cut, around the pipe, then use a sharp stanley knike and trim away.

Chances are, if the springs are orange, they are made from recycled deck chairs......

I've got 37-12.50-15 maxxis creepy crawlers on my 90, with a 2" lift, just needed some trimming

I went to a tube bending place behind where I work, and took a off cut of the roll cage, and they cut me abit off the right size for a fiver.

They are different, but a series bulkhead will fit, but I'd persnally get a propper 90 one, normally, if you can find a series bulkhead in good nick, it cost's more than a 90 bulkhead.

some pics here. Chris

Looking good. What axle is that front one? Chris