portal pete

Not the team mate, just you

Fantastic event with excelent sections, had a few hairy moments throughout the day but managed to keep the truck on four wheels most of the time. Neil, carole and all the team involved you did a fantastic job and i look forward to round 3. Also thanks to frogisland for the great prizes. I think the punchs were very well set out but as said previously a little hard to understand where the intended route was. Again thank you to all involved for putting on yet another great event. Rob Only because i went the wrong way Next time

Managed to sort login details this morning so will see you all sat morning

Its set at 210bar, my drums are 450mm wide so always pulling on the lower layers which helps. Will your system take any more pressure? Rob

Hi Rich what engine will you be running? 60cc+ is way to big and you wont be able to power it unless you've got some serious hp. On the mitsimog we run a 32cc pump belt driven of the crank geared down 1.7:1. With the saley winch and type R 100cc motor this works very well. The typr R 100cc moter has a max 750rpm, if you were to use a 32cc pump direct driven you could only rev to 2000rpm before reaching the maximum motor rpm. Rob

Im affraid i wont be present nor will the little zuk that seems to follow us everywhere. shame to miss such a brilliant site. Its been a fantastic year and i'd like to say many thanks to everyone involved in making the events happen especially neil and carole. Roll on next year Rob

yes simon he's finally entering

pm sent

The saley winch from john sales, fantastic pulling, two speed, drums on bearings and air free-spools a dream

We looked at getting our truck in there, 40ft long 13ft high. We could only see one branch being a problem. Take a ladder and saw in case. might save us taking it down later in the year

See you all sunday

An 8" rim would be fine, i run my 19.5 boggers on an 11" rim and previously ran 16.5 pitbulls on a 9" rim.

Chris Both your motors are M&S hydraulics MR100cc Rob

Tom Both front and rear axle casing's are identical, rears are fitted with a spacer instead of a swivel so converting yours would just require a pair of swivels and shafts. Id just use the axles and put them under a lightweight buggy. Keep the pics coming Rob

I can vouch for that, didnt manage to wash the truck off till thursday so had set like concrete. Was a fantastic event and the punchs were excellent. Water was a little deep in places but after sending the bitch in routes were found around 3-4ft deep.