webbersdad

Gents, Any chance of a link for the 110 CSW (B reg) if it matters. webbersdad

I'm still waiting. The project is currently in limbo pending this and time to make an alternative. webber

You may have misunderstood. Gap the spark plugs to 0.7mm webbersdad

For LPG the ignition system needs to be perfect. Also, on single point systems you should gap the spark plugs to 0.7mm. Don't mess about with ignition timing until you have done this. webber

No. You can use the tank, and tube from the tank to the vaporiser, thats it. webbersdad.

Sounds like a plan, but how long will I need to wait? webbersdad

I've been in contact with Craddocks. They advise that the panel was the last one. They had bought a production over run of the top panel. Sadly the component is no longer available. webbersdad

Lads I now need to buy the complete panel as detailed in the ebygumbay listing; however its sold. Can anyone point me in the direction of another supplier? webbersdad

I note that you've changed the spark plugs. Did you gap them to 0.7mm? If not do so. webbersdad

Do a search on ebygumbay for defender rear step; there are a couple of different options available. webbersdad

My thoughts also. Don't forget that you will need to get the cylinder head/s machined before refitting to the engine. webbersdad

Swap the distributor. webbersdad

My lad works a lot on P38s, with V8s fitted. They can be prone to airlocks, are you sure that you've got the air out of the system? webbersdad

Cheers lads, thats the one. webbersdad

I'm currently restoring a B reg 110 County. Like most the corners of the upper part of the bulkhead have corroded. I purchased the corner repair panels with the longer leg thinking that they would do the job. However my lad has now got stuck into it and the rust has progressed more than the panels will repair. We've already discussed welding in some additional steel sections which seems simple enough. Some months ago, whilst surfing ebygumbay, I notices a re[air panel that was available to cover the whole of the upper section. I've searched again since, but can't find the panel. I've also searched Google and visited numerous website but with no luck. The panel was priced at around £100, which at the time I felt was steep, but now I'm not too sure with the amount of work it would save. I wondered if any member had utilised such a panel, and could advise where I may obtain one? webbersdad