Jump to content

Buzza

Settled In
 View Profile  See their activity

  • Posts

    89

  • Joined

  • Last visited

Reputation

0 Neutral

Profile Information

  • Location
    Halesowen

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Buzza
    Goes in the bell housing, from underneath, and locks into the slot in the flywheel. Steve
  2. Buzza
    Just look here : http://www.pipercams.co.uk/pipercams/www/tech_camshaft_installation.php
  3. Buzza
    Have a look on, discovery2.co.uk under factory add ons, all you need to know is there.
  4. Buzza
    Try these Steve
  5. Buzza
    Are these any help, its a '95 300 tdi. Steve
  6. Buzza
    Just put new cushions and covers on one of mine, it weighs 32lbs. Steve
  7. Buzza
    That's the correct seal, if you look closely at cross section drawing you can see the open side of the seal goes in first, so flat face towards needle bearing. Steve
  8. Buzza
    The cavity side of the seal, where you can see the spring ring, leads in, ie, faces the threaded end of the stub axle. Steve
  9. Buzza
    Think you will find it only comes as part of the pressure regulator assy. LRO16318. Much money !! Steve
  10. Buzza
    Its MXC 5212, brit-car.co.uk have a picture of it. Listed for centre seat but fits outer ones as well. Steve
  11. Buzza
    Looks like the one from the right hand side of the transfer lever housing. Steve
  12. Buzza
    Should have a flange at the open end nearest the regulator so will only fit one way, then the small 'o' ring. Steve
  13. Buzza
    It goes in the head under the fuel pressure regulator Steve
  14. Buzza
    Try here http://www.gwynlewis4x4.co.uk/page80.html Steve
  15. Buzza
    It must be catching, this happened to a mates 110 last week.
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy

  I accept