Hi all,
I've recently replaced the clutch master cylinder on my Td5.
According to LR instructions the resting position of the pedal should be about 140mm above the floor.
All is nicely purged, clear Dot4 fluid without air bubbles is flowing out at the slave cylinder.
The clutch works, however it bites only at the lower 20mm or so of the pedal.
This was also the case before I swapped the master cylinder and I was hoping to improve this.
What I notice however is the bolt on the underside of the pedal box that actually limits the clutch pedal travel.
This can be seen in the Microcat image as item 17.
What is the correct procedure for setting this bolt :?:
Can you guys with a Td5 check how deep you can actually press down your clutch pedal ?
Mine stops at about 2 - 2.5 cm from the bulkhead (so it could go quite a bit deeper).
On my Puma it actually goes much deeper, I have clearly more pedal travel on this vehicle.
All feedback / instructions / suggestions is much appreciated.
Thanks .