biga

Hi Your location of the fuel pump relay is correct, the relay receives its supply via the ignition switch and a inertia switch (C0123) which is located on the left hand side of the engine comartment. The earth return of the relay is thro the engine ecu.Hope this helps Tony

Hi The fuel pumps are controlled by a relay which is turned on by the engine ecu during start up, I would first check or change the relay, check security of multi plug on ecu,there is a good wiring diagram of the circuit in the RAVE download. Regards Tony

Hi The control unit should be fitted behind the LH plastic panel behind the rear seat in the luggage area, if you have rave on your computer it is listed under accesaries in the electrical section. Regards Tony

Many thanks for the replys, It is only the fact that there is one for sale on e bay that had me intrested,but on checking it would seem that it is only suitable for the Discovery

Hello Would any body know if the amigo abs usb tool which is advertised for the Disovery 2 would do the same job on a 2003 Freelander Tony

Hi The discs should be replaced when they get down to 18.0mm,thats 3mm of wear, or if the run out on the disc is in excess of 0.04mm Regards Tony

It sounds like a possible head gasket failure, a compression check would verify that,is there any loss of coolant. As for the fuel injectors the manual states thet the fuel is cut to them on a non starting engine to prevent flooding. If you are getting a spark that proves the crankshaft posistion sensor is ok Regards Tony