Hi
I am looking to repair my front doors. But I can't found anywhere that has all the parts like the skin and the frame..
If anybody could help..
Regards
Mark
Hi
Could any body help. I have got a RRC 3.5 EFI 1987 with 39000 miles but I saw it has just started to leak some oil onto the top of the water pump. I have removed the Inlet manifold and found the gasket was all out of shape. Please see my photos.
Would any body have any idea's why????
regards
Mark
No it was to big.
So what I did was get two new wiper arm with hook ends. I then removed the rivets I was able to remove the arms and springs. I did the same with the new arms and changed them over.
I just could not find and rivets to replace the old ones so I put a bolt though with a lock nut on the end.
Works a treat.
mark
Hi
Could anybody help. I have got a 1987 RRC and the wiper arms connect with the blades with a small pin. But in the rain they are not the best.
Would anybody know if there is a upgrade wiper arm kit. I got new ones but when I went to fit them I found the new ones had smaller holes than the old ones.
Regards
Mark
I would like to thank you all.
Got under the car today and it was the wrong way around. I have ordered a new ball joint and repainted the A frame.
Regards
Mark
Hi
I hope someone could help me out??
I have got a 1987 RRC 3.5 EFI. After to got the car I found that the old rear axle had a lot of holes in it so I replaced it with a new. All the rear bushes have been replaced. I removed the self leaving unit and upgraded the springs.
I have panted all the parts and refit them all. All working great until the rear ball joint broke and came away from each other. After a short drive home I removed the A frame ball joint fulcrum bracket. I got a new ball joint a started to fit it to the car I could get the two nuts a bolts holding the bracket to the A frame arms but when it came to getting the ball joint into the axle I could get into in the hole but not all the war through. I did not mater which way I tried to do it I could only ever get two out of the three to line up.
I then remover the hole axle but i still can't get it to line up.
Any help would be great
regards
Mark