kiall

LRT-44-002 think thats it

Thanks western , I'll give the dealer a bell tomorrow , their might not be a tool but I was told their was one to align the unit .

Sorry ,03 discovery 2 td5 automatic ive got the switch but would like the tool if available? I think their is one or so ive been told .Thanks again

Does anyone have the xyz switch special tool part number , it should be listed with the auto td5's thanks

does the 200tdi have the same kinda p gasket setup as a 300tdi possible that if so

thanks thats the 2 choices i have got from them

Have a small problem with a part identification on a 1998 300tdi cant seem to get the right part number for the temp sender our local landrover dealer has the choice of two , would anyone be able to identify the right one as am on my mac and my pc has sat down

ive heard of them , quite good but mega expensive drills compared to normal ones

it works if u have the hydrogen pre created , but i wouldnt want a tank of it in the motor and the greif its going to cause isnt work will

auto works on fluid being pumped through etc etc , u get a actual holding tool for the front pulley that allows you to torque it up tight

http://www.customcrimp.com/ their expensive but the smaller unit is what we have excpet it sits vertical

4 inlet bent

Well went over to his tonight jumped in fired it up , in neutral clutch up no noise clutch down rumble, so i removed the slave to be greeted but a lump of metal , turns out to be one of the lugs on the pressure/cover place that holds one of the 3 spring it has snapped of the clutch was a ap unit , so engine out at the weekend

On my mates Disco we changed the gearbox about 3 months ago with a unit from ashcrofts , we also replace rear crank seal pilot bearing and clutch and beefed up the pivot point on the fork Now the problem is he is finding it hard to select gears and putting the clutch down in first it continues to drive slighty , i havent been out to look at it going tomorrow but does anyone have any ideas i thought at first might be the slave but as said i havent had a look at it

id did a hole and just push it in lol basically u have a engine and some rubber lol