Jump to content

pitbull63

Settled In
  • Posts

    41
  • Joined

  • Last visited

Reputation

0 Neutral

Profile Information

  • Location
    midlands

Previous Fields

  • Interests
    shooting,motorcycles,rock music and lashings of hot tea
  1. Thats a cool picture mate. Much better than B.G
  2. Had a look at the rear light clusters today and the soldering iron will be out tomorrow as they,re as bad as the dash wiring with twisted wires being the order of the day! Going to get saving for a new loom me thinks
  3. Standard 2 1/4 petrol,electronic ignition and Weber carb but its never had a pull stop.Something else I,ll have to look into.Cheers Would a toggle switch do as a temporary measure for a stop mechanism?
  4. Just remembered its electronic ignition so I,m going to have a look to see how thats wired tomorrow. Had a quick look at the rear light wiring tonight and its been rewired like the dash so I,ll start from scratch tomorrow with things there and see how it goes. Thanks for your help mate
  5. As some may remember I have been sorting the mouse nest that was the wiring loom on my 88" SWB. Well all connections are now soldered up,proper instrument pod fitted,and a dash. It starts,runs great and all the lights work now including the brake lights after I fitted a new switch. I was chuffed as until I went out in it last night to fuel up and when I pulled up in the garage it wouldn,t turn off with the key! A quick think and I sussed out all is ok when the lights are off but the headlights seem to complete the ignition circuit!I,ve also since discovered that the front side lights come one when I brake too! So its back to the drawing board
  6. Hey thats not junk in my Landy!Its stuff I will need.....................maybe......................one day
  7. Never even crossed my mind. Good reason for sharing ideas/experience on here though
  8. Thats what I,ve ended up doing Woody. Got a cracking colour wiring diagram via the lightweight owners site that shows the heaters wiring and then went from there.
  9. Sounds stupid I know but apart from a few other little tricks I,ve started to remove the steering wheel off of my series on a night! A ball ache at times but every little helps
  10. Superb Swifty Just so happens I have recently bought a tap set for another job that I did on a custom bike I built so I,ll get stuck in as soon as
  11. Sorry to hear about this mate Always thought my series was a little less likely to be taken than a 90 but now I,m worried. Hope they get the scum and dish out some proper justice instead of the usual slap on the wrist
  12. Thats deep Anyone enlighten me on how I could do it please?
  13. Hopefully found what I needed.Google is my friend
  14. Been looking at the two wiring diagrams I have got and neither have any wiring in place for the heater blower ! So ,has anyone got a picture of the wiring from the fusebox to through the switch to the blower please?
  15. Stupid question but would it be possible to change the front oil seal on a petrol series 3 lump without splitting the engine?
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy