lyron

at the rear of the injection pump you will find the selonoid. / fuel shut off. check that is operating correctly. we had a similar problem and ended up just swapping thje shut off. worth a try. ron.

if you decide to drop the box, you can do it with all four wheels of the ground. ( on very good axle stands) and use an engine hoist through the passenger door. saves a heck of a lot of struggling especialy if you are doing it on your own. they are very heavy.although mine is a disco 1 the principles are the same.it might be worth while you are at it swapping the dmf for a standard flywheel conversion. ron.

well, thanks to the very helpful post put up by western I now have an almost vibration free disco again. (a bit of fine tuning needed ) many thank for all the advice and input ron.

many many thanks for that western your a star. very helpful indeed . will have another crack at it tomorrow. ron.

non original prop, so does not have any markings whatsoever. it was my own stupid fault for not marking things up before refurb. a mistake I will not be making again. a very valuable lesson learned.have had the prop off and on moving the splined end round one at a time, not quite right yet but a heck of a lot better. will continue tomorrow. have hadf enough for to-day ron.

forgive the title but..just changed the ujs on the front propshaft 300tdi. guess what dewdrop forgot to mark up when I removed the splined end to check for wear on the splines. yep, me!!!! I now have an annoying vibration through the transmission so I am assuming I have got sommat wrong. any advice on how to sort out the configuration of the shaft without me having to take it out and move it one sline at a time. many thanks.. ron.

when i did ours i ended up droping the rear of the box as far as i could then i found it easier to get the socket on, but it was still a bitch to do.just remove the bolts from the crossmember after removing the prop you should be able to get to the top bolts with a stack of extentions jack engine back up and split the box. ron.

many thanks for the quick reply. hve done a temp repair with a bit of rubber hose but still need to find one that don't cost the flippin earth. ron

could any one tell me where i can get a new one from please. they seem to be very difficult to find. many thanks. ron.

without a doubt, lift pump. ron.

good morning folks, the warning lights came on the disco 2.(usual ones,abs etc)so checked wheel bearings,YIKKES!!!!! were they bad. got a new set .put em on for him so all sorted, now, the question i am going to ask is, he wants to know if there is any way he can reset the warning lights without going to the main stealers. many thanks. ron.

many thanks for the quick reply, will be purchasing new o e,as we need it to last. once again, thank you. ron.

advice needed on wheel bearings, can you get seperate bearings or do wehave to buy the complete hub, many thanks for any advice. ron.

just a thought, try using diesel for a while and see what happens. ron.

we get about 40 on a run with ours(manual not auto) you say it's rubbish, what are you actualy getting? if it's in the 30s you will be about right. also what fuel are you using. i e cheap supermarket or decent stuff. if you can hear air being sucked in check intercooler pipes paticularly the one going to the inlet manifold, also you could check inlet manifold gasket, a very simple job. it may well benefit from a thorough service, sorry i can't be more helpfull. ron.