Jump to content

Billy Whizz

Settled In
  • Posts

    28
  • Joined

  • Last visited

Everything posted by Billy Whizz

  1. Give liveridge 4x4 a call based near j3 m42 they have Autologic diagnostics and can read any LR right up to 2012 theyshould get to bottom of it ;0)
  2. Hi I had probs with my freelander key I went to Liveridge 4x4 in earlswood nr j3 of the m42 the guy sorted it with there autologic cost 48 +vat they do computer work for the main dealer but cheaper may be worth a try
  3. I had the same fault on a 06 defender changed crank sensor cleared faults problem gone
  4. Hi ftc 4785 is the right one for your disco
  5. If you need a pump I should have one at work let me know cheers Bill
  6. don't know if you have sorted this but i got called out to a freelander after a diy headgasket job turned out the guy had cam wheels fitted wrong just remove bolts to check pins in both cams fitted line up as i refitted cam wheels correctly and it fired up first turn of the key I hope this helps
  7. either of the above or possibly the water rail running at the back of engine under inlet manifold may be worth putting a pressure check to see under pressure, unless water is leaking in to cylinder bore and exiting out of exhaust i have had that before
  8. move air filter housing and look at front of gear box see if you see a black plastic slave cylinder if so that may be the problem but clutch arm can sieze in gear box but probably hydrolics comes complete pre bled with master cylinder costs about £100
  9. Hi Colin i have had the same sort of thing with the defender td5 and found the injector seals worn replaced them and problem sorted may be worth checking but be careful the injectors are a tight fit DON'T lever against the plastic rocker cover it will break and its not cheap!!! cheers Bill
  10. You need to plug it in but until then try unplugging the MAF sensor underneath the cover by the air filter if performance is better then that may be your cause Also list your area in case we can guide you to a decent dealer who can plug in. Billy
  11. Great how to guide Les but the gasket i used was a thick multi layer with a black shim that goes on top i find they do a few more miles Keep up the good work Billy
  12. Check condition of pipe from block to rocker cover i have had a few split on the inner edge and MO IS RIGHT A LITTLE OIL GOES A LONG WAY
  13. Part no for TDI fuel filter is AEU 2147L plenty of used Disco filter housings around
  14. Tom hi mate i have put a few disco engines in defenders and i dont change fly wheel housing i just remove all studs apart from the top 3 then slide them together and refit studs that line up then drill and tap the others. Use defender mounts on disco engine and use disco rad and intercooler with defender surround as you dont weld, you can use disco surround with some basic welding then a mixture of water pipes and a defender wiring loom or just the plug off the loom (i may have a plug at work) I am in birmingham so not to far from you so if you need any parts or info P M me Cheers and good luck Billy
  15. Hi all just had a TD4 52 plate come in at work non starter those men in the yellow vans say fuel pump as it starts with a little sniff of easy start but after disconecting fuel pipe we have fountain of fuel so would seem ok Glowplug light lights up but goes out with engine management light after a few seconds should this be longer?? Have plugged into my mac tools scanner but has no faults stored i would like to get sorted as cheap as poss as its my mates motor so if any of you have had simular probs please help Billy
  16. Check swivel bearings if camber is out rock wheel top to bottom check if complete hub moves
  17. check for holes in the inner wings under bonnet and rear seat belt mounts by rear arches
  18. Hi Tand 200disco swivels are the same new or second hand try Liveridge 4x4 in earlswood just off junc 3 m42 not to far from you
  19. I've got a D1 drop arm PM me if you are interested Cheers Billy Whizz
  20. Hi Rob believe they do fit but should use spigot adapter rings quite cheap of ebay as new shape rangies centres are smaller
  21. Hi Tonka make sure you hav'nt cross threaded it then hold lower half of shock tight (above axle ) with large mole grips or i use either a chain grip or large adjustable pliers
  22. Is it worth flushing rad just in case as we had a 300tdi running warm at 70ish turned out previous owner liked RADWELD changed rad and all was ok! in responce to disco / defender rad oil cooler pipes don't the adapters unscrew??
  23. Have you fitted the disco rad that came with engine??? Definatley use defender sender unit as Western says
  24. Hi i know if you go to a garage with a T4 or simular computer you can alter alarm/immobilizer functions or dissable altogether B)
  25. I agree my mate had one fitted and i'm sure it cost him less than 400gpb including the rear crossmember i will ask him exact price if you want Billy Whizz B)
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy