The injector pump has diesel dripping from the 6mm allen screw just behind the mounting flange.Before loosening the screw,I have tried to find out what could be lurking behind it spring,valve etc.Other VE pumps do not appear to have this screw.Does anyone know what its purpose is?Could it be just a case of renewing an O ring or fibre washer?
Sounds like you have inadvertently changed to oil filled hubs.....not a bad conversion!But you will have to replace the single lipped oil seal FTC4785 with the double lipped seal RTC3511 if you want to avoid leaks. Also check the surface it runs on for pitting or wear.If necessary replace the stub axle or redi sleeve the area the seal runs on.
The rear may have been converted to oil fed.See if the oil seal in the stub axle has been removed,the single seal oil seal holding the inner wheel bearing would have been replaced with a double lipped oil seal RTC3511.
I have just changed the fuel filter on my 1999 Defender,unfortunately lost the plastic fastener[butterfly screw]
that secures the steel protective cover WKT100020 .Have been unable to find the part number for a replacement screw.
Are they available as a separate item?
Western,Thanks for the reply,that clip you show would do the job.The broken one I removed looks like this
I guess it may even be from something not LR related.
This clip is broken on my 1999 Defender.I ordered a new one PRC3180 but it is different to the original.
The old one does not have a mushroom end,but more of a 'W' on the bottom half followed by a square section on which sits the actual clip.
Anyone recognise this description and know the part number?
I have just received a box for my 1999 Defender[QAF500110]Bought from LRDirect it is listed as a Britpart item but is brand new from Adwest complete with drop arm.
Cost was £256 no vat but postage to OZ was £87.50 delivered in a week,so well pleased!