phil37

Will it have to be reset in both control units then ?

Hi western I have sent digidash a message thanks Phil

Hi here goes I recently fitted a second hand bcu to my disco two then with one click of the button on the nanocom I managed to click up a hundred thousand miles. Question is does anyone know where I can get it reset to the miles it was before this happened. Thanks phil

Hi here goes I recently fitted a second hand bcu to my disco two then with one click of the button on the nanocom I managed to click up a thousand miles. Question is does anyone know where I can get it reset to the miles it was before this happened. Thanks phil

Hi guys I am looking to get my td5 defender temp gauge working with a v8 engine. Can anyone tell me the part number of the sender that I need. Thanks phil

Simon did you ever get to the cause of your problem. Phil

As dave has said changed mine last year due to the lights coming on. Not had them on since Phil

Thanks western

Hi i am looking for the part number for the temp gauge on a tdci also the fuel gauge on the same vehicle if any one has them. phil

Hi all anyone know what can network the tdci runs on and if anyone can do a analogue to can interface Thanks phil

I am looking for a stainless steel finisher for my 90 it has a 3" pipe fitted Phil

Did you do any good with this conversion . Me and my son am having a go at this conversion I am on holiday with me laptop with the wiring diagrams on iPad with Internet connection and my note book writing things down its looking do able at the moment fingers crossed. Phil

Would the earth connect there due to it being a earth for the fuel pump itself (electronic fuel pump). Landrover use what they call headers which is a point where one conection t`s off to another. Phil

Al i think i read the post wrong i do not have a bell housing it was the flexi plate and housing for the raer of the engine. Phil

Hi i want to fit a master door lock switch to the dash board (TD5 middle dash). Do they do one for the defneder or can you use a discovery td5 one. Phil

Hi my lad has a td5 that came out of a auto which he wants to put a manual gearbox to if thats any good to you. Phil

Hi westurn it looks like it is number 32 on the 1st page.I thought that the insert stayed in the slam pannel but by the looks of things it don`t. I ask because i have brought a RDX front grill and they supply screws but i have nothing to screw into. Off to the RDX web site i think. Phil

Hi all i am after the part number for the screw inserts on the front slam pannel on a defender td5 air con.The holes are round if that makes a diffrence. Phil.

Hi all i am trying to wire up the central locking on my defender doors i have, The doors am off a td5,I am currently using a td5 bulkhead and loom. I want to convert the loom to run my 300tdi engine.Question is i have got 4 wire on the o/s door they are orange. yellow. yellow and pink and black from the looks of things they all went to the arlam box which i have taken off and put a after market on but i still want to use the central locking but i cannot find any pin out diagrams fot the alarm box ecu. Can anyone help Phil if you want to reply direct due to it being a secrity issue my email is philgreen37@hotmail.com

Has it as been said heat and drill should do it.

That looks like a r380 tunnel. Phil

thanks for that off in the garage with me meter. phil

Hi can anyone tell me where the plug is that comes out of the bulkhead for the aux power that goes to the rear of a td5 90 please. Phil

Hi i need to know where the pipes go from that cylinder o/s/f n/s/f etc. Thanks Phil

Hi its non abs 90 thanks phil