Hi There
Try WEMA UK for senders and gauges they are the slide tube type
they also supply flange plates to mount to the top of the tank
dead easy to fit and about 50 pound for sender and gauge
Hi all
I know that this topic has been on before, but i have just acquired 2 sheets of 8x4 chequer plate free and seeing as i have just cut out my old floor on an L plater i thought that i might use this instead. Can anyone see any problems am open to suggestions
Hi there have just taken a gearbox off a V8 engine that i have had sitting around fro a couple of years. The gearbox number on it is 25 27 7484 suffix D. Could anybody tell me what the ratios are and if is the strengthened type? Am looking to fit into an 80 inch trialler. Any info much appreciated!!
Good repair instructions, if i may add a small bit to it and that is sometimes you might
have to turn the two slip rings on a lathe as they are not usually true and you might experience brush bounce
sometimes you can use the old comm end bearing in the lathe as a guide
Thanks for the info
can anyone be a bit more specific about the straight bit. Also this rangey will only be used for trialling and it has been scrapped
many thanks