Hi, bit of advice required please!
Would a LT77 V8 gearbox fit a 200 tdi engine?
I have my old gearbox to swap the bell housing over.
Are the first motion shafts the same or..
Easily swapped?
Finally is £300 a reasonable price for a good low mileage LT77 ?
Cheers Barry. ..
I cut out my bulkhead on my S2a 17 years ago and replaced it with...NOTHING!!!
It's a Soft-top too and nothing has moved,the doors still shut fine.
So......My answer is.....Don't waste your time fitting/fabricating one!
I've a steel plate between the hoodsticks so it's hidden from view...
A Mag-mount will grip through the canvas and the coax passes
through the Door-shut to the radio.
Mine's been inuse for 3 years now without any problems...
Good show but......
Most......No...... ALL of the work was done by others!
Friend of mine had it back to his garage to finish off what other "Experts"
had Balls-up
Wait to you see the 80"
We use them to mount the Press Button boxes to traffic Light poles.
They weigh a couple of Kilos and, in over 25 years,I've never seen a PB box dangleing by the wires!!!
I would never just weld a winch tray to the chassis.......
Saw one rip out and take a lads knee cap straight off once!
I can still hear the screaming...
I would not put it on my Landrover either.
OK for pulling a dead ROLLING car up a trailer but that's it!
Saying that £60 is a fair price but the solenoids will cost a bit!