cougard

Hi all. I want to replace my stock cooling fan on a TD5 with an electric one. I've read conflicting info on whether a Mondeo fan fits or not. Has anyone fitted a Mondeo fan onto a TD5? Thanks, Matt

Well I have changed the pump and all is well again. Thanks for the help guys.

I have done it the cheats way and cut a hole in the rear tub floor. When I put me ear right to the pump, I can just hear it but it is very quiet. I am going to drop a new pump (well, second hand but working fine) in tonight and see if it solves the problem. Matt.

That's the most accurate description of the sound! Exactly what it was doing. Looks like new pump time then.

Thanks all. I have a feeling its going to be the pump on the way out. It was making a nice humming noise a few days back but now it is suspiciously silent . I did put my ear to the floor of the rear tub and cant hear a sound. Is there an easy way to check if the pump is working? What id i disconnect the fuel line from the side of the filter and turn the ignition on? Thanks, Matt.

Hi all, I seem to have developed an engine stutter/lack of power. Its a 110 2001 TD5. The problem suddenly started on my way back home one night. It drives fine in the lower rev range but starts to stutter and produce very little power in the higher rev range. I have replaced the injector loom back in July and cleaned out the plugs on the ECU. I will look for signs of fresh oil at the injector loom plug tonight. Anyone have any ideas on where to look next? Thanks, Matt..

Hi bm52. I am also in Kent. Whereabouts are you? Matt

I get my led's from this guy. http://www.crazyleds.co.uk/catalog/ Very good service.

Thanks Mike. I will take a look.

Do CPC stock a suitable cable? I have had a look but can't find anything meaty enough.

That's what I was thinking western. Any ideas where I can get a set of replacement brushes from? Thanks, Matt.

Hi all, I'm in the process of refurbishing a Warn M8000 that was dead. I finally got round to taking the motor off today, popped the end cap odd and this is what has happened... Now I'm sure that should all be in one piece! The back brush has shattered and the wires have come away from both the brush and the bolt/terminal. This is the first time that I have played with winches so I'm a bit stuck here. I have tried to solder the wires back on but it just won't take. Is there anywhere that I can buy some new brushes? Is there a different way to fix it? Any help is very welcome Matt.

Thanks all. Great help.

Thanks for the advice guys. Any idea on what price I shood be looking to pay for a TDS 8500 motor? Thanks, Matt

So you removed the red plug from the ECU under the drivers seat and it was full of oil? If thats the case then you will need to change the injector harness as the seal on the plug has gone. Your local LR Dealer will also tell you that the whole engine loom will need replacing but this is usualy rubish. Once you have changed your injector loom, clean out the ECU end of the harnes with some contact cleaner. Put a whole load in and keep spraying until it runs clean and the oil has gone. Check it every few days and repeat if needed. Soon the oil will stop comming and you may just be lucky and not have to change the loom. This happened with my 2001 TD5. Changing the injector harness is not a hard job. Took me around 20 mins to do the whole lot and it was the first time I had taken the top off! Matt