Jump to content

Search the Community

Showing results for tags 'heatshield'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • The Lounge
    • International Forum
    • Modified Vehicle Builds & Special Projects
    • Getting out and about
    • Competing in Land Rovers
    • Tools and Fabrication
    • The Video Shack
  • Tech Archive
    • Land Rover Technical Archive
    • Requests for Part Numbers
  • Vehicles
    • Series Forum
    • Defender Forum
    • Freelander Forum
    • Discovery Forum
    • Range Rover Forum
    • Military Forum
    • Evoque Forum


There are no results to display.


  • LR90's Blog
  • geoffbeaumont's Blog
  • My 1991 RRC 4.0 V8
  • Doublecab Happenings

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 1 result

  1. Dickie_L_J_O

    1992 Range Rover Classic 3.9EFi

    Good evening, I’ve recently been doing a bit of work on my Range Rover. Lower steering column, pads and rotors, clutch master and slave... I drove to work in the rain for a test drive, everything seemed fine. I fired her up and drove home, nothing to report, apart from when parking up in the garage... After reversing in, I started to smell burning. I hurried in, switched off and opened the bonnet. I could see two spots glowing red around the new slave cylinder. Has anyone experience this before? I was hypothesising that I had installed the heat shield mat slightly off and it was touching the cat. The whole setup seems flawed by design, with the slave being that close to the slave, it made the change a right PITA, as none of the bolts was visible. Awful picture sorry, hard to see the glowing. Any tips? Is the heat shielding doing more harm then good? Any help appreciated, - Richard

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy