Jump to content

Search the Community

Showing results for tags 'weld'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • The Lounge
    • International Forum
    • Modified Vehicle Builds & Special Projects
    • Getting out and about
    • Competing in Land Rovers
    • Tools and Fabrication
    • The Video Shack
  • Tech Archive
    • Land Rover Technical Archive
    • Requests for Part Numbers
  • Vehicles
    • Series Forum
    • Defender Forum
    • Freelander Forum
    • Discovery Forum
    • Range Rover Forum
    • Military Forum
    • Evoque Forum

Calendars

There are no results to display.

Blogs

  • LR90's Blog
  • geoffbeaumont's Blog
  • My 1991 RRC 4.0 V8
  • Doublecab Happenings

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Been practicing welding vertical lap joint, 3mm new stuff to ?mm chassis. After a few pigeon poo runs i managed this. I think it's ok but please, advice and guidance is welcomed. The image is correctly orientated ie the chassis section was stood on end. Upside-down next... <shudder>
  2. Hi all, I have a small, rusted hole in the bulkhead, just to the inside of one of the bonnet hinges. I was going to weld it initially, but I can no longer get hold of a mig, so I'm coming up with alternative suggestions... I'm currently looking at Evo-Stik's hard & fast metal epoxy putty, and my plan is to strip all the paint and rusty metal off, apply an anti-rust solution (any recommendations?), allow that to dry, then fill the entire hole with the epoxy putty (and thereby hopefully prevent it from coming away at the edges). Conveniently enough, my 90 matches smooth white Hammerite perfectly, so I was then going to paint over the putty with Hammerite. If it doesn't work out, I'll just have to get it welded in the future, but can anyone see any problems with my current plan? I'd appreciate any advice you can give me! Cheers, Will P.S. I also have a reasonably large dent in one of the wheel arches. Any tips on getting dents out?
×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy