Gazzar Posted November 25, 2017 Share Posted November 25, 2017 I'm stripping down a series LT76 at the moment. Removing the front output flange reminded me that I've lost the flange holder I made years ago. So I made a new one. 1 Quote Link to comment Share on other sites More sharing options...
Gazzar Posted November 25, 2017 Author Share Posted November 25, 2017 It took half hour, and some scrap off-cuts I saved from the recycling. Quote Link to comment Share on other sites More sharing options...
Retroanaconda Posted November 25, 2017 Share Posted November 25, 2017 Good stuff. I did similar the other week for a tool to hold the engine while I did up the crankshaft bolt: Quote Link to comment Share on other sites More sharing options...
Gazzar Posted November 25, 2017 Author Share Posted November 25, 2017 That's the way to do it! Quote Link to comment Share on other sites More sharing options...
Maverik Posted December 1, 2017 Share Posted December 1, 2017 On 2017-11-25 at 2:31 PM, Retroanaconda said: Good stuff. I did similar the other week for a tool to hold the engine while I did up the crankshaft bolt: Wow... that is quite special.... Quote Link to comment Share on other sites More sharing options...
Retroanaconda Posted December 1, 2017 Share Posted December 1, 2017 Might look rough, but it was made out of what I had laying about. And it worked Quote Link to comment Share on other sites More sharing options...
landroversforever Posted December 2, 2017 Share Posted December 2, 2017 I do love a home-brew tool! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.