Gazzar 134 Posted February 13 Melted equals heat, so poor connection somewhere. Dab of copper slip on the contracts should sort that. Plus a good earth. But they should not melt, irrespective. Share this post Link to post Share on other sites
roverv8 7 Posted February 14 Turns out after a few pics they are sending out replacement lights 😊 1 Share this post Link to post Share on other sites
Maverik 211 Posted February 14 I've given up on those type of bulb holders and lenses, they're ridiculously poorly made even the genuine ones. I think I'm going to be putting the LED module type on the next truck. 1 Share this post Link to post Share on other sites
roverv8 7 Posted Friday at 04:08 PM I’ve only got then as they were cheep and when it comes to putting in the new td5 loom I can just get on with it while I adapt my led lights if I adapt them now they not going to fit the current loom so it means landy will be off the rd longer then should be have these won’t have to start cutting plugs off can sort led’s in my own time my biggest problem is the light plug orange plug trying to find on of them Share this post Link to post Share on other sites
roverv8 7 Posted Saturday at 03:50 PM Got new replacements today still bit iffy but stayed on for an hour while I had breakfast so not to bad Share this post Link to post Share on other sites
roverv8 7 Posted Tuesday at 06:55 PM Has anyone got a photo of a TD5 windscreen washer bottle plz? I believe they are just behind the n/s head light Share this post Link to post Share on other sites
Scotts90 174 Posted Tuesday at 11:18 PM same as puma models too Share this post Link to post Share on other sites
roverv8 7 Posted 12 hours ago Thank you 😊I like the look of that Share this post Link to post Share on other sites
roverv8 7 Posted 11 hours ago (edited) So the chassis loom turned up today very happy now it’s just a case of plug in job done ✅ got a few plugs any ideas guessing one is tow bar electrics, fuel tank, pump, gauge, low fuel light,? where would the rear wiper electrics be? see photos Edited 10 hours ago by roverv8 Share this post Link to post Share on other sites
roverv8 7 Posted 10 hours ago Getting there DB340301-E262-4196-AD64-66FFC71623BB.MOV Share this post Link to post Share on other sites
western 400 Posted 10 hours ago The wiring diagrams I sent you gives all the info & colour codes, just match them with the loom. Share this post Link to post Share on other sites
roverv8 7 Posted 10 hours ago 3 minutes ago, western said: The wiring diagrams I sent you gives all the info & colour codes, just match them with the loom. cool, will do ralph 1 Share this post Link to post Share on other sites
Scotts90 174 Posted 4 hours ago Yes, the large grey plug with orange insert is for the towing elecs . Wiper electrics will be dependent on which loom you have. If it’s configured for it then you should have a natural coloured plug along with the nsr light plugs. This does the wiper/wash functions, oddly enough the remote central locking for the tail door (again if configured) comes from the roof part of the loom. Share this post Link to post Share on other sites