ped Posted May 5, 2023 Share Posted May 5, 2023 I have to fit a new diff nose oil seal to my rear axle on my 110 and last time i did it i made a rough flange spanner I had a good look around the workshop and no sign of it so I've started on a new one I had an old propshaft flange that was a bit damaged so i set to and chopped it up a bit then machined it more presentable and I'll weld a lump of bar on for the handle Quote Link to comment Share on other sites More sharing options...
Gazzar Posted May 5, 2023 Share Posted May 5, 2023 I bought one on eBay. Not nearly as much fun. But quick. Quote Link to comment Share on other sites More sharing options...
Snagger Posted May 6, 2023 Share Posted May 6, 2023 I could do with one. I bought the materials to make one, just need some welding rods and a mask. Might continue with it as another little project. How much did yours cost, Gary? Quote Link to comment Share on other sites More sharing options...
Gazzar Posted May 6, 2023 Share Posted May 6, 2023 Recognise the axle stand? Quote Link to comment Share on other sites More sharing options...
ped Posted May 7, 2023 Author Share Posted May 7, 2023 Lever welded on Cast steel never welds great but should do the job 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.