serendipity Posted September 6, 2007 Share Posted September 6, 2007 As a student project we are building a lathe from scrap parts, using an old 4 cylinder engine block and crankshaft. In the same spirit of "we did it just because it seemed like a good idea at the time" has anyone tried converting a trasformer-welder to work as a plasma cutter? One should imagine the principle is simple, but the fettling required considerable. I also have little wish to be informing parents their little darlings have gone up in a blue flash so any do's and don'ts would be well received.... Quote Link to comment Share on other sites More sharing options...
Troddenmasses Posted September 6, 2007 Share Posted September 6, 2007 Good for you. Have never done this, but can't really see why not. Wear rubber gloves and enjoy yourselves. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.