Les Henson Posted September 25, 2007 Share Posted September 25, 2007 You know how it is - friends yapping, rushing to get the job done, running late, sandbag moaning, trying to get it done before the rain comes, etc etc. Lucky I realised before too long Les. Quote Link to comment Share on other sites More sharing options...
keithjh Posted September 25, 2007 Share Posted September 25, 2007 ouch Ouch Ouch! Did that on my 110, only i got a bit further than you did (okay a lot further) picking tools up to put away to see release bearing still in box, on top of the dash regards Keith Quote Link to comment Share on other sites More sharing options...
white90 Posted September 25, 2007 Share Posted September 25, 2007 At least is shows you are mortal Les Quote Link to comment Share on other sites More sharing options...
dollythelw Posted September 25, 2007 Share Posted September 25, 2007 my personal fave pic up V8 release bearing from the shelf instead of stubby 4 pot bearing..... joy Quote Link to comment Share on other sites More sharing options...
general-confusion Posted September 25, 2007 Share Posted September 25, 2007 Just glad to see another blockwork drive looking just like mine...with all the block joins Full of MUD !!! Quote Link to comment Share on other sites More sharing options...
landrover598 Posted September 25, 2007 Share Posted September 25, 2007 Been there, done that, only it was the grease for the bearing. Lucklily there was no body on the landy, so getting the props off and the box out was a bit easier. Quote Link to comment Share on other sites More sharing options...
LandyManLuke Posted September 25, 2007 Share Posted September 25, 2007 I changed the clutch, bolted it all back together, tunnel back in etc. then the push rod fell into the bellhousing. feckin clip. Quote Link to comment Share on other sites More sharing options...
RedLineMike Posted September 25, 2007 Share Posted September 25, 2007 I changed the clutch, bolted it all back together, tunnel back in etc.then the push rod fell into the bellhousing. feckin clip. did that on christmas day & to cure it put a holesaw through the bellhousing Quote Link to comment Share on other sites More sharing options...
Bull Bar Cowboy Posted September 25, 2007 Share Posted September 25, 2007 You know how it is - friends yapping, rushing to get the job done, running late, sandbag moaning, trying to get it done before the rain comes, etc etc.Lucky I realised before too long Les. I think I would be seriously pi$$ed off ...........................however, many, many years ago I did start up a rebuilt engine, but forgot to put the oil in it first ............ expensive mistake...... Ian Quote Link to comment Share on other sites More sharing options...
Mo Murphy Posted September 25, 2007 Share Posted September 25, 2007 I know that awful sinking feeling on realisation Mo Quote Link to comment Share on other sites More sharing options...
Les Henson Posted September 25, 2007 Author Share Posted September 25, 2007 the push rod fell into the bellhousing. feckin clip Ah, but there's a trick Luke B) Les Quote Link to comment Share on other sites More sharing options...
LandyManLuke Posted September 25, 2007 Share Posted September 25, 2007 Definitely, Les. This was before i was older and wiser, and before forums. I was 18 at the time. hmmm, bit older now, maybe not wiser. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.