SteveRK Posted March 10, 2008 Share Posted March 10, 2008 Few pictures of the repair/replacement so far: Piece of 2mm thick mild steel clamped to the underside of the floor ready for welding. This will then be welded to the crossmember (two small holes to be enlarged) This is the off-side: Plug welded, ground down and then 'Tetrasealed': Repeated on the other side and now with the crossmember welded in and 'Tetrasealed' all over - Lovely stuff to use Next up will be the front crossmember replacement that hopefully will follow the same method, then the arse end member Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.