maxtherotti Posted June 28, 2009 Share Posted June 28, 2009 hi all i was checking the car over today and found some slight play in my nsf hub i know how to do the rears but have never done the fronts lol is it just a case of taking off the circlip and dropping the drive flange off and adjust as per the rears or am i over simplifying it?? thanks rob ps its a 98 300tdi manual Quote Link to comment Share on other sites More sharing options...
sheltie50 Posted June 28, 2009 Share Posted June 28, 2009 I think your right, certainly on the older axle that was the case, are you sure its the wheel bearing and not the swivels. Quote Link to comment Share on other sites More sharing options...
Les Henson Posted June 29, 2009 Share Posted June 29, 2009 Front and rear adjustment is the same. Les. Quote Link to comment Share on other sites More sharing options...
bobtail4x4 Posted June 29, 2009 Share Posted June 29, 2009 but dont forget the bolts for the drive member, one of them is needed to pull the driveshaft back to get the circlip on, then stick the bolt back where it belongs, Quote Link to comment Share on other sites More sharing options...
maxtherotti Posted June 29, 2009 Author Share Posted June 29, 2009 thanks chaps rob Quote Link to comment Share on other sites More sharing options...
allegedly Posted June 30, 2009 Share Posted June 30, 2009 Hi Rob, If memory serves, there's a good piece on this in the Tech section, I used it myself a while back. Cheers Rob Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.