ajh Posted February 22, 2010 Share Posted February 22, 2010 When I bolt the sliders up the front attaches to the bulkhead bolt fine, the back lines up with the middle removable tub crossmember, but the one intended to bolt to the back outrigger has about a 1cm gap between the bracket and the outrigger. (obviously on a 110) Any ideas? Just make some spacers and chalk it up to poor measurement either on the part of Challenger or of Richards? Quote Link to comment Share on other sites More sharing options...
ajh Posted February 22, 2010 Author Share Posted February 22, 2010 Really, nobody? With only the two ends bolted up they're really nowhere near strong enough either. I am thinking that some fabrication is going to be needed to add some attachment points closer to the main chassis rails, i.e. not through the thin ends of the outrigger and crossmember before I'm likely to actually trust them much. Quote Link to comment Share on other sites More sharing options...
Richy B Posted February 22, 2010 Share Posted February 22, 2010 Really, nobody? With only the two ends bolted up they're really nowhere near strong enough either. I am thinking that some fabrication is going to be needed to add some attachment points closer to the main chassis rails, i.e. not through the thin ends of the outrigger and crossmember before I'm likely to actually trust them much. Give paul a call @ challengers ?? Quote Link to comment Share on other sites More sharing options...
ajh Posted February 22, 2010 Author Share Posted February 22, 2010 Yeah, spending a couple bucks a minute just did not seem sensible. I was hoping someone else had similar experiences and could offer some insight. I'll send him some email. Quote Link to comment Share on other sites More sharing options...
ajh Posted February 22, 2010 Author Share Posted February 22, 2010 Oh, I owe him an apology, they're not from Challenger at all, they're from the deadbeat that runs Safari Equip. (got the tub tree sliders from Challenger, which are fine.) I think I need to sue this Safari Equip guy to get the rest of my parts, 6 months and I still don't have proper installation instructions for my fuel tanks, the ARB spacers, or the stainless steel vent covers that were missing from my shipment in September. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.