paintman Posted March 30, 2010 Share Posted March 30, 2010 Alternatively, just drop the whole lot repeatedly on a hard surface from a great height and all will be well. They may not separate, but at least your frustration will be vented!! :lol: Quote Link to comment Share on other sites More sharing options...
DC_ Posted March 30, 2010 Author Share Posted March 30, 2010 well it's off. !!! ya dancer !! Tightened nuts up a little and gave it a lil tappy tappy. Got big hammer and gave the side of the disk a few hundred slaps. Undone nuts........ Fell out !! now just need to wait til the snow and force gales go away and I can get on with finishing the job. Thank you people !! Quote Link to comment Share on other sites More sharing options...
DC_ Posted March 31, 2010 Author Share Posted March 31, 2010 Thought I'd share the finished article. When followed the LR4x4 manual for this job I'd just like to add the shaft on my RRC didn't allowed the flange bolt in the end as the flange bolt is too big. Had to use a much smaller thread to get the shaft out enough for the circlip to be put back on. Quote Link to comment Share on other sites More sharing options...
DC_ Posted April 3, 2010 Author Share Posted April 3, 2010 Other side was much easier due to all the help given . Ring out job done Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.