Jump to content

Push rod clip


jad
 Share

Recommended Posts

Hello everyone

I am currently rebuilding my car. When i took it to pieces I had some people round to help me :rolleyes: Which was nice cos it was completely in pieces by the end of day 1. However one of them :angry: too the clutch slave cylinder out with push rod and therefore the clip off.....

The engine and gearbox are on the new chassis with bulkhead, rear tub floors in drivers side wing on etc

My problem is i cannot for the life of me get the push rod clip back in with the push rod! since i can fit only fit one of me fingers in with it.

By any chance has some one got a tip for putting this back in without separating the engine and gearbox? I have broken the original clip that came out, then ordered 4 more because i don't fancy my chances.....

Is there a trick to it or do i have to take the engine out?

cheers

Jad

Link to comment
Share on other sites

good point...

sorry was annoyed and wasnt thinking!

I have for once managed to use the search function! and found a fair few topics. hopefully one of these should help me get it back in.

cheers

Jad

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy