Jump to content

109 CSW Roll cage / sill bars build thread


Recommended Posts

isn't it for wading? saves trying to find the hook under water. :)

i dunno why there's one on the drivers side, thats why you take slaves people out off-roading! ;) ;)

There isn't one on the drivers side of the cage......

Link to post
Share on other sites

may i point this out to you? ;):P

Can I point this out to you -that's way below the windscreen line and nowhere near the winch loop on the passenger side... more likely for wing bars if you ask me ;)

Link to post
Share on other sites
Can I point this out to you -that's way below the windscreen line and nowhere near the winch loop on the passenger side... more likely for wing bars if you ask me
they are on both sides that means there to hold the wings inplace
the lower ones are to keep the wings in place

Wrong, Wrong and wrong.

They bolt to the footwells, in a effort to give the bulkhead a little more rigidity.

Link to post
Share on other sites

Wrong, Wrong and wrong.

They bolt to the footwells, in a effort to give the bulkhead a little more rigidity.

Well at least I didn't think it was a winch hook :P

Very nice idea too -I find my series bulkhead wants to flop back and forward a fair bit too, in fact I am sure it is where some of the squeaks are coming from!

Link to post
Share on other sites
and i, Landy-Novice take the golden prize for getting it correct! :i-m_so_happy::i-m_so_happy:

You'd allready proved you were wrong by copying the pic into paint and circling the bit you were wrong about!

Now back to the 109;

155971998_photobucket_37722_.jpg

155971998_photobucket_37700_.jpg

155971998_photobucket_37708_.jpg

So just as it was looking finished, i cut the ends off the rear x member.

155971998_photobucket_37724_.jpg

Link to post
Share on other sites

It does blend in well ... if you excuse the fact it is clean in comparison to the rest of it ;)

What are the plans for the rear cross member? is it strengthening to support the two down pipes from the roll cage?

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy