Jump to content

110 measurement required.


Recommended Posts

Could one of you kind fellows take a measurement from the centre of the rear wheel to the face of the cross member. I'm trying to work out what exhaust might be close to fitting the ibex currently I'm thinking td5 110 rear, chopped td5 130 mid and disco 200tdi front.

Thanks mike

Link to comment
Share on other sites

I've got a rear section in the shed at home which I mistakingly bought - I think it might be either a 200Tdi or 2.5NA rear section for a 110 rather than the 300Tdi which I needed. It had the wrong mating flange for mine. Since I'm never going to use it then if you can put it to use then by all means have it. Perhaps a small donation to the forum?

Link to comment
Share on other sites

I've got a stainless disco rear but it was to far off to make it worth cutting.

I reckon the td5 110 will be pretty close hence wanting the measurement.

Ed I may be interested but I have to have a rolled tail pipe for the iva and I was aiming at rear exit but I'll do a bit of research and get back to you.

Mike

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy