sweeney110 Posted August 31, 2015 Share Posted August 31, 2015 Hello all. Not been on for a while as everything's been running smoothly.I had to change the ignition switch and now my horns not working. I've a black wire im assuming is the problem as only one end is connected.it's connected with a purple wire and I can't fine where the other end should be. Anyone any ideas? 1987 110 csw if that makes any difference. Thanks and I hope someone can help. Connor Quote Link to comment Share on other sites More sharing options...
western Posted August 31, 2015 Share Posted August 31, 2015 if these plain black & purple/black trace wires at the the Horn then plain black is Earth & purple/black trace is the horn feed from the stalk push end at steering column, purple/black trace to the horn +ve terminal plain black to -ve terminal & bolted via one of the bracket bolts at bonnet slam panel. once reconnected it should -- beep beep if it's at the stalk end there will be a bare pin or unconnected bullet terminal for it to match with. see pic of mine below [1989 110, but wiring is the same] it's the lower slightly darker purple wre/black wire, the go in as shown the feed up the stalk to horn push. Quote Link to comment Share on other sites More sharing options...
sweeney110 Posted August 31, 2015 Author Share Posted August 31, 2015 That's brilliant western. I see where it goes on your pic. It was the lower down slightly darker purple wire I need to connect to. Thanks I'll try in the morning Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.