Hello all - recently registered but lurked for a while and have tried to search and haven't been able to track down what I'm missing.
Short backstory, I daily drove my 5-speed 4.0 Discovery through most of undergrad...then I was unable to keep up with maintenance/excuses and it's sat. Bought a used 4.6 engine a few years ago and the buddy that was helping install it passed away, so it sat a few more years. I'm now trying to tackle it again and replacing the ECU with the Megasquirt kit from Nigel. The engine is installed, though there was no spark and the buddy wanted to Megasquirt it. Sounded like a fun venture so that's what we decided...just never got around to buying the kit until a few months ago.
My current issue is the alignment of the crank pulley. I've attached a few pictures of the original pulley that I have. With it, everything lines up but the "dome" pushes the timing wheel back and it hits the bottom of the water pump.
I found an old 4.6 pulley (that doesn't have the "dome") and it's way too close to the engine block.
What am I missing? Are the timing cover dimensions different between the 4.0 and 4.6?
Thanks for any help,
Nate