Hi all
Your help would be much appreciated,
Been running MS1 kit for my RR 3.9 , very well so far and loved it. Had an issue with IAT & CAT sensor readings after rebuilding the engine and so I tried the Easytherm to calibrate them.
I believe I made an error by flashing the Megasquirt with the Easytherm rather than placing the inc files in the TS project file (also with EDIS plugged in !!). The ECU is now corrupt and does not connect to the Tuner Studios. It even did start and ran the car as usual but could not load TS to load the tune no matter what.
It's not a cable or COM port issue I am pretty certain but I could be wrong.
So trying the last resort, I tried to flash the ECU with boot loader pins connected and loaded MS1 Extra 029y4. The loader prompted download complete and seemed ok. But now I have two problems.., it won't connect still, and worse, it won't prime the fuel pump when turning ignition key since it's a fresh new firmware. When I try creating a new project, it won't detect the new firmware.
I even tried Portcheck.exe and it does find the COM 3 I used to connect with, but "not connected" prompt is reported in the checker, of course.
Tried everything I know but I am stuck and fear it might be finished.
How do you usually flash the unit? Do I now go to the original Firmware and flash with 029y3?
Is there another way of resetting the ECU apart from reflashing? why the TS won't see the ECU?!! Cable is fine, was using it, and the drivers are fine. I even setup another laptop and still same issue.
Amir