Jump to content

MITCHF

Settled In
  • Posts

    65
  • Joined

  • Last visited

Posts posted by MITCHF

  1. Hi all, I have a problem and need some directon.

    The Brake warning light on the dash is flickering occasionally, more noticeably down hill ?

    Only other symptom, the handbrake is right at the top of it's travel and just holding.

    Fluid is OK.

    Me thinks brake pads ?, front or rear ?, if it's handbrake what do I need to look at ?

    Cheers

  2. I have a 96 300TDI and I'm planning to upgrade/renew my suspension.

    I do light off road and some easy green laning, nothing extreme so I don't want lift.

    I was going to go with -

    HD Springs and Gas shocks

    or

    HD springs and Std Oil shocks

    The original kit has done 90k, the backs seem alright but the front's starting to sag a little due to some extra hardware I've added.

    What's the general opinion.

    Cheers :)

  3. Hello, before you give me stick for worrying about the CD player in a 90 :D , hear me out.

    My old man bought himself an '06 XS 90 (25k mls) 3 months ago from an official LR dealership. (not cheap :o , hense me asking the question)

    It went back in as the CD player regularly skipped. (December)

    Problem solved at LR dealer, in for a couple of hours, new unit fitted.

    New CD now won't play, 2 weeks after getting it back.

    It's obviously going back again but anyone heard of this before ?

    Cheers All

  4. it's a common problem i'm afraid, usually worse when there are inclement weather conditions such as snow or flooding - usually the time when LR''s come into their own :)

    You are soooo right, it's got much worse since we've had snow :o

  5. I have a 95 300 Auto and whenever I go out in it I get a "smile" on my face.

    If I go off road the "smile" just get's bigger.

    Is this normal ?

    I've seen other Disco drivers waving to me who appear to experiencing the same problem :lol:

  6. Stick some fine powdered graphite in it, will probably sort it temporarily but you may need a new barrel and key in the long term.

    CHEERS bOGMONSTER.

    I THINK i'M AT THAT POINT NOW, WENT OUT THIS MORNING AND IT WON'T BUDGE :angry:

  7. it could be the fork has began to wear though the pivot point, air in the system, worn leaking slave cylinder, try bleeding it first and see what happens

    Mine did the same, did the slave and master cylinder.

    Problem solved :)

    Clutch fork would have been my next possibility.

    Good luck

    PS. Clutch & Slave is not an expensive job

  8. hi :)

    just a quick question i am running 235/70/16 at the moment but need some new rubber i have found some 245/70/16 will these fit a standard hieght disco with out any mods

    all the best Roy

    Hi Roy, yes they will, no mods needed.

    Got them on my std Disco 1.

    Cheers, Mitch

  9. anything to report on economy? or indeed emmissions...

    The economy is slightly better over the last few weeks, although I'm currently running down a full tank to compare to the full tank pre mods (same type of use). This will take a few more days, then I'll have a tangable comparison.

    The emmissions appear better but not tested, I used to get a black belch from the exhaust on start up, rev up high and when it changes to top at 50mph (auto). I still get some smoke but it's not black and there's less of it.

    The performance has improved (not a sports car) but there is some improvement, more noticeable from 50 -70.

    The K&N I fitted was a panel filter direct replacement, not an induction kit, so there is no intrusive induction noise.

    Cheers

×
×
  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy