Steve 90 Posted November 19, 2008 Share Posted November 19, 2008 Can anyone have a measure up of a Toyota landcruiser (80 series) half shaft (diff end and general shaft dia) and CV (stub shaft and bell). I know there no direct comparison that can be made to other axles as material type and design have a massive effect but it will give me a reasonable idea what the possibilities are if specials need to be made and if the axle casings and diff are a good staring point. Also a hub face to hub face measurement would be great (width of axle to where wheels mount) Cheers. Steve. Quote Link to comment Share on other sites More sharing options...
pugwash Posted November 19, 2008 Share Posted November 19, 2008 will measure all that tomorrow morning and post up then mate- haev a spare set of Halfhsafts and CVs out of the vehicle at the moment. Quote Link to comment Share on other sites More sharing options...
Steve 90 Posted November 19, 2008 Author Share Posted November 19, 2008 will measure all that tomorrow morning and post up then mate- haev a spare set of Halfhsafts and CVs out of the vehicle at the moment. Cheers fella. Quote Link to comment Share on other sites More sharing options...
TomG Posted November 19, 2008 Share Posted November 19, 2008 According to: http://www.arb.com.au/resources/pdf/airLoc...ation_chart.pdf 80 series shaft diameter is 33mm (1.31") and 30 spline at the diff end Quote Link to comment Share on other sites More sharing options...
Steve 90 Posted November 27, 2008 Author Share Posted November 27, 2008 Cheers Tom. Had chance to measure yours yet Puggers??? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.