anyone got drawings for bell housing holes.......

[zen]

looking to make an accurate (dont like the one i have made,seems ok ,but boss away next week and workshop mine..)adapter plate for toyota v8 onto lt95 box...

so need accurate drawings (cad?) for lt95 bell housing bolt holes in relation to input shaft..

thanks

[integerspin]

looking to make an accurate (dont like the one i have made,seems ok ,but boss away next week and workshop mine..)adapter plate for toyota v8 onto lt95 box...

so need accurate drawings (cad?) for lt95 bell housing bolt holes in relation to input shaft..

thanks

I did a drawing for a V8=>series box adapter. But never cast one and verified it on a block, the

old adapter I took my measurments off had a few pretty oval holes.

I can't find it right now, I am sure i have seen it on the laptop, I will have a look on my old laptop.

Found some jpg's so I now know the filename..

[zen]

I did a drawing for a V8=>series box adapter. But never cast one and verified it on a block, the

old adapter I took my measurments off had a few pretty oval holes.

I can't find it right now, I am sure i have seen it on the laptop, I will have a look on my old laptop.

Found some jpg's so I now know the filename..

thanks

[integerspin]

CLICCKME

For pdf of V8 block-face

The holes that look like they should be symetrical aren't, accoriding to the dimensions.

I would want to check all these on a block before cutting any metal, like I said the holes In the adapter I

took the measuments off were all pretty bad. The crank center is the origin.