bear
-
Posts
415 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by bear
-
-
Are you able to check the fuel pressure? Should be 4 bar at the FPR.
Griff
-
Purge cycle is with ign on, press accelerator fully 5 times. Engine management light will flash and run the cycle to purge air from the fuel system.
Not a difficult job. How To on UP's site here
http://www.discovery2.co.uk/Injector Seals.html
Griff
-
Yes there is a none return valve in the fuel filter housing. Rear outer if I remember, but please check. Does it start after doing the purge cycle? If so I suspect its the injector copper washers. Plenty of info if you search.
Griff
-
1
-
-
-
On my 2004 it's 15mm.
HTH,
Griff
-
I've got General Grabber AT3s on mine. M&S and snow symbol - seeing where your located.
Griff
-
You have 2 seals on the injectors. Bottom copper one will allow combustion gas into fuel and cause starting issues, Rubber O ring seal will allow diesel into oil and cause oil level to rise on dip stick.
Griff
-
Hi, I'm no expert but could it be the injector back lash needs adjusting? Hopefully the more knowlegable will be along soon.
Griff
-
1
-
-
Hi Simonr, Don't think there are relays under the seat on the D2. Are you thinking of the TD5 Defender?
Griff
-
Have you tried starting it after dong a purge cycle? If it does then there's air getting into the fuel system and may need the injector washers/copper o rings renewing.
Griff
-
Glad you're sorted and thanks for letting us know the result.
Griff
-
Check the small connection on the starter motor. They can come loose.
Griff
-
Glad you're sorted.
Griff
-
Hi, If the red led on the dash goes out (even though it wont start) then it's not imobilized. Are you able to check the starter motor is ok?
Griff
-
They're actually under the seat, but I mentioned this as it is a known problem and is what to look for.
Griff
-
On the D2 it's usually the plug that's come unplugged.
Griff
-
1
-
-
Not getting up to temperature is certainly a thermostat not working as it should but bear in mind that when really cold it does take a while.
Griff
-
Hi, Has the SLABS been programmed and set to coils. I suspect it's still on the air setting. You'll need Nanocom/ Hawkey or similar.
Griff (Too far away to help)
-
Do you have access to Nanocom etc to check the roof receiver is working?
Griff
-
When mine started to missfire when warm it turned out to be the injector loom. However, Nanocom did read a fault code.
What is the noise in the first clip like an air leak?
Can you check the fuel pressure by putting a gauge in place of the fule temp sender on the FPR. Should be 4 bar
Griff
-
If they're not leaking they're empty 😄
Griff
-
If it's the engine the usual suspects are the front cam seal or rocker cover gasket at the rear.
Griff
-
-
Hi, I'm no expert but I think reving it that high does seem a bit excesive. I don't feel the need to go above 3000 rpm.
Griff
Where does this go??
in Discovery Forum
Posted
Hi, Not sure - try checking the wire colours with a wiring diagram to see what they should be for. Maybe for something you don't have fitted as there are redundant connections on mine.
Griff