Right when I on tick over the a/f number is figure is 14.9 when when I drive the number dies to 9.00 then when I coast it pops back to 14.9 any ideas. Thanks
Hi all I have got my truck running and all timed up right... Hooray?????????? right I am very new to the whole Megasquirt and tuning but getting it slowly.
Right auto tune. Is it as easy as ve table 1- tools- auto tune. Then drive it hard/slow/cruising/ up hill/ downhill etc. then saving it.?? Thanks
Hi I'm 99% sure the edis8 has gone wrong somehow. I'm only getting 1 bright spark then after that they are half as bright out of the left hand side coil packs. I have tried swaping the 'a' & 'b' signal wires(at the edis end) round and then the spark moves across to the other side. I've double checked every wire and every connection. Uv got the vr sensor correct(one way round I get nothing no rpm or spark) the way it is now I get rpm and spark. Is there anything I could have over looked?? The battery is in charge and I'm getting a good 10+v while cranking. Crank rpm is around 140/150. Any help or ideas welcomed. Thanks
Hi all I'm pulling my hair out here. I have just fitted a Ms1 kit to my rover 4.2. Serp belt. I not getting a spark. I have got the vr sensor in the correct way. Iv got the battery on charge so I'm getting a good 10+v on cranking. Iv double checked all wiring. I did get it running for about 20 seconds the other night before it cut out. But now I have no spark again. Any ideas?? Thanks rob