[Levelling Unit spanner size]

I've removed several of these "things" the only method which worked for me was a good sharp chisel and nicely weighted hamer, if your replacing the joint it should come with a new nut and pin, I alson found that removing it from the A frame required a press but maybe I was just unlucky.

[Range Rover Forum]

In the process of fitting a 200tdi into 1983 Rangy, I have read that the input shaft lenght on the long lever lt77 is different, donor is 1993 Disco,

Any clues.

[Which is the odd one out???!!!]

I thought this changed when the 5 door came into production, but maybe not ? My 83 5 door slope's

[Range Rover classic 2 door, how do the front wings attach at the botto]

There are 2 bolts which go through the wings and through the sill trims, there is also a bracket running fron the bottom of the wing backwards but I cannot remember where they fasten, I lost mine during a rebuild years ago, the wings have been fastened to the trim only since with no problems.

[200tdi into range rover]

Thank you all, this is the info I was looking for, going to try the conversion this weekend but with limited time ?????

I will write a problem report for others.

Wish me luck.

[range rover classic]

Just a thought, you could try testing or replacing the temperature sensor, it could be telling the ECU lies like it's -40c.

Good luck.

[wireing up a range rover]

Hi,

Iv'e seen several R/R with the same prob, it will run very well and then turn into a bag of sh, my bet's on the ignition amp but something in the back of my mind says, A conection prob on the loom running through the valley between cylinder heads and feeding the dizzy.

[Oh Nooooo]

Recently noticed a "click" from the rear wheels.

Any ideas??????

Brakes? bushes? any common probs?

Cheers

Tom

Check the propshaft uj, could be the rear one staring to wear out.

[Dismantling fuel injector pump on 2.4 vm]

I took one apart a few years ago lost the timing marks and coukld not remove the crank damper so could not set it up again, exit left vm !

[Rust on the rear - is this an MOT fail?]

I replaced mine last year as most of it had been lost on the road but had to jack the rear back into position, dont leave it to long.

[Rust on the rear - is this an MOT fail?]

Hi,

You need to a bit carefull here as the rear of your r/r might be a little soft, I have seen the goalposts moving on very bad examples, replacement is not such a bad job if you can weld and will be a cure for many years.

[200tdi into range rover]

Only a couple

Thanks for that I'm in a funny position where I have two complete disco's with rotten bodies and good mechs plus my trusty 1983 R/R which is in decent order, where I live petrol is £1.15 per litre and thats just crazy, poor old v8 will find a home in my MGB so all is not lost, done lots of swaps before but still looking for info, tried a search here but found very little will try again.

[200tdi into range rover]

I plan to install a 200tdi into my 1983 classic, any info or tips, anyone done this.