RangeyRover Posted April 6, 2009 Share Posted April 6, 2009 Front RRC Bulkhead Body mounts Part Number? Place to buy? or am I making one up? Made a cardboard template but its a lot of fuss. Thanks RR Quote Link to comment Share on other sites More sharing options...
steve_d Posted April 6, 2009 Share Posted April 6, 2009 I doubt they have a part number because they were part of the body. However that does not mean an aftermarket company does not produce them. Could not find them when I looked so made my own. Steve Quote Link to comment Share on other sites More sharing options...
ThreeSheds Posted April 7, 2009 Share Posted April 7, 2009 I couldn't find any either so I made some out of rear mounts. This (I have now decided) was a mistake. It was awkward with lots of unmeasurable angles and hence involved a lot of welding up in-situ (so as to make sure it all lines up). Next time I will do it differently: From the few I have lookad at (about four I think) it appears that the ones on the Disco of the same age do not rust in the same way as those on the RRC, and so next time I will be looking to cut them out (complete with as much floor as I need) of a scrapper Disco. You could have had the ones out of my donor Disco, but I have plans for them myself Roger p.s. When you assemble the new one, put the bolt in from the bottom, otherwise, with the rubbers in place, you can't get it out again without cutting a hole in the footwell.. Quote Link to comment Share on other sites More sharing options...
RangeyRover Posted April 7, 2009 Author Share Posted April 7, 2009 Thanks Guys. Sheet metal origami it is then. I've made a drawing so Ill publish it for other RRC sufferers. Maybe we can persuade someone to make it. RR Quote Link to comment Share on other sites More sharing options...
denski Posted April 11, 2009 Share Posted April 11, 2009 Sheet metal origami it is then.I've made a drawing so Ill publish it for other RRC sufferers. I think I'm one of those sufferers Quote Link to comment Share on other sites More sharing options...
RangeyRover Posted April 15, 2009 Author Share Posted April 15, 2009 As promised, Origami Bracket for RRC. This fits mine, make sure you check in paper or card first that it will fit yours. RR RRCBracket.pdf Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.