ajh Posted March 11, 2010 Share Posted March 11, 2010 I asked this before but I cannot find the thread. I was wondering if anyone had detailed assembly pics for a ground-up build? Preferably a 200TDI 110 but any would help. I am at the point of attaching one wing and am a little confused as to why the bolt holes to the chassis do not line up, I am assuming there is something else between them. Quote Link to comment Share on other sites More sharing options...
mike4444244 Posted March 11, 2010 Share Posted March 11, 2010 Hi I assume that the bulkhead is in the correct place, and the wings are fixed at the bulkhead end, and that the front panel is fixed? I have always found that the holes don't line up exactly and you need to use a wiggle bar (steel pointy thing) to line the holes up How far out are they? mine were as much as an inch in places as the wings moved around! Mike Quote Link to comment Share on other sites More sharing options...
ajh Posted March 11, 2010 Author Share Posted March 11, 2010 Well, what should the angle of the front wing be? There seems to be about half and inch horizontally and about an inch vertically, and the top of the wing is more or less level as it is. Quote Link to comment Share on other sites More sharing options...
ajh Posted March 11, 2010 Author Share Posted March 11, 2010 I did put up a photo if you follow the link below and go to the last page (probably on the last page, I put it up last night). Quote Link to comment Share on other sites More sharing options...
Jurriaan Posted March 11, 2010 Share Posted March 11, 2010 I have some disassembly pics on these two links: http://www.mijnalbum.nl/Album-BSUXJ48A http://www.mijnalbum.nl/Album-W7WMBE84 Some pics might be useful to you? Quote Link to comment Share on other sites More sharing options...
mike4444244 Posted March 12, 2010 Share Posted March 12, 2010 ahhh I think I see your problem, the wing is not out 'up and down' its twisted, if you imagine rotating the wing around the headlight hole it should line up, being a relatively flimsy panel with a heavyish end there is plenty of 'give' when refitting, just manipulate it until the holes line up Mike Quote Link to comment Share on other sites More sharing options...
ajh Posted March 12, 2010 Author Share Posted March 12, 2010 Yeah, it was the inner fender position/warp. A jack, a 2x4 and some patience and I got it right. (photos up) Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.