bmhor Posted March 11, 2010 Share Posted March 11, 2010 Morning All, I've just picked up and old Crypton 290 gas analyser which is reporting that it's out of calibration. How can I disable the calibration as I want it for information rather than exact figures. On the back there is a block of small "DIP" switches with a sticker over them saying that the Calibration is invalid if removed, so I'm guessing that they have something to do with it.. Any help, manuals etc. would be appreciated. Bob Quote Link to comment Share on other sites More sharing options...
Highway_Star Posted March 11, 2010 Share Posted March 11, 2010 Probably a service engineer only job, there's likely something in the MOT specs that won't allow this to be done easily. My dad had a Sun analyser that had been nobbled by a Snap On bloke to bypass the calibration, was done with a laptop. Set him back about a ton IIRC, but that was a few years back now. good luck with it Bob! Quote Link to comment Share on other sites More sharing options...
bmhor Posted March 12, 2010 Author Share Posted March 12, 2010 Probably a service engineer only job, there's likely something in the MOT specs that won't allow this to be done easily. My dad had a Sun analyser that had been nobbled by a Snap On bloke to bypass the calibration, was done with a laptop. Set him back about a ton IIRC, but that was a few years back now. good luck with it Bob! Thanks Pete, I'm hoping it wont come to that...... Bob Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.