tommac Posted April 21, 2010 Share Posted April 21, 2010 Im going to be changing the injector seals and washers on the td5 atthe weekend- having read through various posts on here all appears straight forward- any one have any advise to offer? Thanks in advance! Quote Link to comment Share on other sites More sharing options...
carlosbeldia Posted April 21, 2010 Share Posted April 21, 2010 Tommac, how much does it cost these seals and washers? do you have the code? anything else that must be changed? Quote Link to comment Share on other sites More sharing options...
tommac Posted April 21, 2010 Author Share Posted April 21, 2010 carlos, the seals and washers (genuine landrover) work out to be about £24 over here in the uk. As far as i can tell the only other item which may be required is a new rocker cover gasket. Quote Link to comment Share on other sites More sharing options...
SiWhite Posted April 21, 2010 Share Posted April 21, 2010 The old rocker cover gasket can be reused - the workshop manual states to use two blobs of silicone at the rear of the engine. A slide hammer is invaluable - some folks have used a small pry bar instead. Quote Link to comment Share on other sites More sharing options...
tommac Posted April 21, 2010 Author Share Posted April 21, 2010 ideal- will aim to re use the gasket then! dont havea slide hammer so will attempt to use small pry bar instead! Quote Link to comment Share on other sites More sharing options...
freefall1 Posted April 22, 2010 Share Posted April 22, 2010 hi ,I used this small plumbers pliers as a pry bar to remove one of my injectors,Just make sure to place it under the main body of injector not solenoid end, Quote Link to comment Share on other sites More sharing options...
tommac Posted April 22, 2010 Author Share Posted April 22, 2010 thanks for the tip freefall- i shall use a simailr tool! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.